What helps tile and slate repairs last with Brumshield Roofing and Building
Close material matching
Replacement tiles or slates are chosen to suit the existing roof as closely as possible.
Support beneath inspected
Battens, underlay and fixings are checked where broken coverings expose them.
Targeted repairs done neatly
Local damage can often be put right without disturbing sound areas around it.
A small break can open a bigger problem
A cracked tile or a slipped slate might look like a small job, but the repair still needs care if the roof is going to stay weather-tight. We deal with missing, broken and weather-damaged tiles or slates, along with defects affecting ridge tiles. Before replacement starts, we identify the existing covering as closely as possible by material, size, profile, colour and fixing method. That helps the repaired patch sit in properly. We also check what has been exposed beneath the damaged area, because a broken tile can be the result of an issue lower down, not just bad luck.
Matching the covering and checking beneath it
When coverings have slipped or broken, the battens, underlay and fixings beneath them may also need attention. Ignoring that can turns a tidy-looking repair into a short-lived one. We lift what is necessary, deal with any supporting defect we uncover, then replace and secure the tile, slate or ridge detail so the roof's weather protection is restored. Choosing our team means targeted repair where the wider roof is still sound, saving you from larger work when the problem really is local. With Brumshield Roofing and Building, a matched repair is meant to sit properly and stay there.
Frequently asked questions
Can broken tiles cause bigger problems?
Yes. Once a tile or slate is cracked, slipped or missing, water and wind can reach the underlay, battens and fixings beneath. A small visible break can therefore lead to wider trouble below the surface if it is left to work away through repeated wet weather.
Do replacement tiles need to match?
As closely as possible, yes. We look at the material, size, profile, colour and fixing method of the existing covering before choosing a replacement. That helps the repair sit correctly on the roof and keeps the weather protection consistent across the repaired area.
Do you inspect under the broken area?
We do. When coverings are removed or found missing, we inspect the battens, underlay and fixings that have been exposed. If there is a supporting defect beneath the visible damage, we deal with that as part of the repair so the new tile or slate is not just sitting over the same problem.